Connecting The Power Cord - Pioneer AVH-2300DVD Installationsanleitung

Section
01 Connecting the units

Connecting the power cord

Navigation system
(AVIC-F220 (sold
separately)).
Please contact your dealer to
inquire about the connectable
navigation system.
Note:
Depending on the kind of vehicle, the
function of 2* and 4* may be different.
In this case, be sure to connect 1* to 4*
and 3* to 2*.
ISO connector
Note:
In some vehicles, the ISO connector may be divided
into two. In this case, be sure to connect to both
connectors.
4
En
26 pin cable (Supplied with Navigation system)
Insert the 26 pin cable in the direction
indicated in the figure.
2* 1*
4* 3*
Yellow (2*) Yellow (1*)
Back-up Connect to the constant 12 V
(or accessory) supply terminal.
Red (4*) Red (3*)
Accessory Connect to terminal controlled by
(or back-up) ignition switch (12 V DC).
Orange/white
Connect to lighting switch terminal.
Black (chassis ground)
Connect to a clean, paint-free metal location.
RGB input
Antenna input
Connect leads of the same color to
each other.
Fuse resistor
Fuse resistor
Speaker leads
Front left 
White:
White/black: Front left 
Front right 
Gray:
Front right 
Gray/black:
Rear left  or subwoofer 
Green:
Green/black: Rear left  or subwoofer 
Rear right  or subwoofer 
Violet:
Rear right  or subwoofer 
Violet/black:
This product
Fuse (10 A)