Connecting The Power Cord - Pioneer SPH-DA01 Installationsanleitung

Section
02 Connecting the system

Connecting the power cord

ISO connector
Note
In some vehicles, the ISO connector may be divided
into two. In this case, be sure to connect to both
connectors.
8
Engb
*1
*3 *2
*5 *4
Cap (*1)
When not using this terminal, do
not remove the cap.
Yellow (*2)
Yellow (*1)
Back-up To terminal supplied with power
(or accessory) regardless of ignition switch position.
Red (*3)
Red (*4)
Accessory To electric terminal controlled by
(or back-up) ignition switch (12 V DC) ON/OFF.
Orange/white (ILLUMI)
To lighting switch terminal.
Black (GND)
To vehicle (metal) body.
Blue/white (P.CONT)
To P .CONT of control line cable.
Note
Depending on the types of vehicles, the
function of *3 and *5 may be different. In this
case, be sure to connect *2 to *5 and *4 to *3
as shown in the figure.
Connect leads of the
same colour to each other.