ZAMEL extra free Bedienungsanleitung Seite 9

CAUTION: While changing the battery, it is suggested to press any of the buttons for
about 5 seconds before putting it into a latch. Next press transmission button several
times to check its operation. If the transmitter does not work properly repeat the battery
change procedure.
SUBSTITUTING THE BATTERY WITH ANY BATTERY OF
INCORRECT TYPE MAY CAUSE AN EXPLOSIVE HAZARD.
DISPOSE OF USED BATTERIES AS STATED IN THE MANUAL.
RADIO TRANSMITTERS PROGRAMMING
MONOSTABLE mode:
1. Press transmitter's push-button for a longer time.
2. Press PROG push-button of ROP-01 device for a longer time until LED red diode switches on
(constant signal). Next release PROG push-button.
3. Release transmitter's push-button. LED red diode switches on (first signal pulsates, next the
signal is constant).
4. Press the same transmitter's push-button and release it. LED red diode switches on (the signal
pulsates) and next it switches off - THE TRANSMITTER IS ADDED.
BISTABLE mode:
1. Press PROG push-button of ROP-01 device for a longer time until LED red diode switches on
(constant signal). Next release PROG push-button.
2. Press the transmitter's push-button for a longer time. LED red diode switches on (first signal
pulsates, next the signal is constant).
3. Release transmitter's push-button. LED red diode switches on (the signal pulsates), next the
LED red diode switches off - it means the TRANSMITTER IS ADDED.
SWITCH ON/SWITCH OFF mode (two push-buttons):
1. Press PROG push-button of ROP-01 device for a longer time until LED red diode switches on
(constant signal). Next release PROG push-button.
2. Press and release transmitter's pushbutton. LED red diode switches on (first signal pulsates,
next the signal is constant).
3. Press and release the same transmitter's push-button. LED red diode switches on (the signal
pulsates) and next it switches off - THE TRANSMITTER IS ADDED.
TIME mode (one push-button)
1. Press PROG push-button of ROP-01 device for a longer time till LED red diode switches on
(constant signal). Next release PROG push-button.
2. Press and release transmitter's pushbutton. LED red diode switches on (the signal pulsates,
next the signal is constant).
3. Press and release the same transmitter's push-button. LED red diode switches on (the signal
pulsates) and next it switches off - THE TRANSMITTER IS ADDED.
An exemplary programming procedure with the use of P-257/2 remote controller.
The procedure for the rest of radio EXTA FREE transmitters is analogous. CAUTION: Every
transmitter can cooperate with ROP-01 in a different mode, depending on how they were
added to the device. One transmitter can be added during one programming cycle. Full
memory is signalled with pulsating LED red diode.