FITFIU FITNESS GYM-100 Betriebsanleitung Seite 47

STEP 8
Once the machine is assembled, check if the cable is tensioned (At the correct tension, there should be a 3-5mm gap
between the top plate and the weight stack).
If the cable is slightly loose, tighten it by tightening the bolt on the top of the weight stack.
If the cable is too loose, adjust the length of the spiral chain (#55), using the snap link (#58).
47
GYM-100
Loosen the nut
and screw the bolt
into the top plate to
give the cable the
correct tension and
retighten the nut.
EN