Assembly And Use; Strap; Tripod - Art. 413; Kit 10 M Tube And 10 Nozzles - Art. 412 - Stocker Geyser Benutzerhandbuch

Strap

The practical strap makes it possible to hold the nebulizer in strategic
positions above the ground.
To use the strap, attach the buckles at either end of the belt to the
attachments protruding from the sides of the nebulizer.

Tripod - Art. 413

The tripod is already included in the package of Art. 411 - Geyser
Nebulizer 12 L Li-Ion; it can be purchased separately for Art. 410 -
Geyser Nebulizer 4 L Li-Ion.
The tripod is a practical accessory for lifting the nebulizer 49 cm
off the ground and conveniently holding it at strategic points in
green areas. To assemble the tripod, screw the 3 aluminium poles
one by one onto the underside of the nebulizer, where there are 3
threaded holes.

Kit 10 m tube and 10 nozzles - Art. 412

The tube and nozzle kit is not included in the package, but can be
purchased separately and used with both the 4-litre nebulizer
(Art. 410) and the 12-litre nebulizer (Art. 411).
The 10-metre tube is the ideal accessory for carrying out mosquito
repellent treatments in small gardens surrounded by fences, hedges
or other ornamental plants, and can generally be fixed around a
perimeter at strategic points to extend the range of treatments. It
comes with 10 ultra-fine spray nozzles and 10 quick T-connectors.
60
Art. 410 / Art. 411
Geyser Nebulizer 4 L and 12 L Li-Ion

Assembly and use

Art. 410 / Art. 411
Geyser Nebulizer 4 L and 12 L Li-Ion
Assembly and use

Assembly

How to assemble the tube - Art. 412

Users can assemble their own tube adding up to 10 nozzles:
1. Cut the tube at the points where you want to apply a nozzle
2. Insert the tube into the attachments of the quick connector
3. Insert the nozzle on the connector
4. To detach the tube from the quick connector, press the end ring of the connector and pull
the tube out.

Connecting the tube to the nebulizer

1. Remove a nozzle from the nebulizer: press the ring of the connector on which it is inserted,
then pull out the nozzle.
2. Connect the tube directly to the attachment previously used for the nozzle.
3. Close the end attachment of the quick T-connector of the tube with one of the plastic caps
provided.
1
For further information about the product, please contact info@stockergarden.com.
1
3
2
2
4
3
61