Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Recommendations - EUROM FLOW 250 Gebrauchsanweisung

Tauchpumpen
Vorschau ausblenden Andere Handbücher für FLOW 250:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

BEFORE USING YOUR PUMP...
Read this entire instruction leaflet carefully. It contains important information in relation
to the use of your pump and precautionary measures that may need to be taken.
Reading these instructions thoroughly will ensure you get the very best performance
from the product and ensure maximum safety.

SAFETY RECOMMENDATIONS

 For safety reasons, your submersible pump must always be connected to an earthed
socket that has been installed according to national regulations, forms part of an
electricity network that is equipped with a fuse of at least 16 Amp and has an earth
leakage circuit breaker (nominal voltage ≤30 mA).
 Check your pump, electrical cable, plug and socket before each use. Do not use if
the device is damaged and have this damage repaired by an accredited electrician.
The cable is an H05RN-F type.
 Ensure that electrical connections stay dry at all times. Do not touch them with wet
hands.
 Protect the electrical cable and plug from heat, oil and sharp corners.
 Clean the drainage pipe before use.
 Before use, check to ensure that elevation height does not exceed your pump's
capacity.
 Do not use the electrical cable or the drain hose to hang up, lower or move the
pump. Attach a rope to the handle in order to do this. Never pull on the cable to
remove the plug from the socket but remove by pulling on the plug!
 Rinse the pump with clean water if you have used it to pump water that contains
chlorine, for example, or deposits. Ensure the pump is not used if it cannot drain off
the water due to issues such as blocked drainage, elevation too high, etc. This will
damage the pump!
 Do not use the pump if there are persons present in the object to be pumped out. It is
forbidden to use this pump in a swimming pool.
 Sand (and similar materials) in the liquid that is to be pumped will have a corrosive
effect and will lead to increased wear and tear.
 Allowing the pump to run dry will increase wear and tear and cause overheating.
Always prevent the pump from running if no water is being moved and switch it off
immediately if this is the case.
 Close supervision is necessary when the product is used near children, incapacitated
persons or pets. The device is not suitable for use by persons (including children)
with a physical, sensual or mental limitation or a lack of experience and knowledge,
irrespective of whether they are being supervised or have been issued with
instructions in relation to the use of the device by a person who is responsible for
their safety. Always ensure that children cannot play with the device.
 Never repair the pump, cable and/or plug yourself; always have this maintenance
carried out by an authorised expert. The importer and manufacturer accept no liability
for repairs and/or modifications to the pump if they have been carried out by
someone who is not qualified to do so. Such interventions also nullify the guarantee.
9
EN

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Flow 400

Inhaltsverzeichnis