Electrolux EIV9467 Benutzerinformation Seite 30

Induction cooking zones adapt to the
dimension of the bottom of the cookware
automatically.
When you place the cookware in the correct
position, the hob recognizes it and the
appropriate control bar comes on. A red
cooking zone indicator appears above the
control bar and indicates the position of the
pot.
Each square on the control panel represents
one cooking zone on the induction cooking
surface. Zone indicators show which cooking
zone is controlled by the appropriate control
bar.
5.4 Heat setting
1. Press the desired heat setting on the
control bar. You can also move your
finger along the control bar to set or
change the heat setting for a cooking
zone.
2. To deactivate a cooking zone, press 0.
Once you place a pot on the cooking zone
and set the heat setting, it remains the same
for 2 minutes after you remove the pot. The
control bar and the cooking zone indicator
blink for 2 minutes. If you place the pot on
the cooking zone again within this time, the
heat setting reactivates. Otherwise the
cooking zone deactivates.
30 ENGLISH
5.5 OptiHeat Control (3 step
Residual heat indicator)
WARNING!
/ / As long as the
indicator is on, there is a risk of
burns from residual heat.
The induction cooking zones produce the
heat necessary for the cooking process
directly in the bottom of the cookware. The
glass ceramic is heated by the heat of the
cookware.
The indicators /
cooking zone is hot. They show the level of
the residual heat for the cooking zones you
are currently using.
The indicator may also appear:
• for the neighbouring cooking zones even
if you are not using them,
• when hot cookware is placed on cold
cooking zone,
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the cooking
zone has cooled down.
5.6 Bridge
This function connects two cooking zones
and they operate as one. You can use the
function with large cookware.
1. Place the cookware on two cooking
zones. The cookware must cover the
centres of both zones.
turns white.
2. Touch to activate the function.
3. Set the heat setting.
The cookware must cover the centres of both
zones but not go beyond the area marking.
/ appear when a