Concept VI1020 Bedienungsanleitung Seite 49

EN
WARNING!
• After cooking has finished, there is residual heat in the glass-ceramic plate coming from the cooking utensil. Pay extra
attention as the heat zone is hot and you can be burnt. This residual heat can be utilised.
• The touch control is activated by placing a finger on the required symbol on the glass-ceramic plate. Therefore, keep
the control panel clean and dry.
• The control panel must be kept clean and dry.
• Make sure the appliance is prevented from being accidentally switched on, e.g. by kids or pets.
• When the hob is disconnected from the mains, the set-up parameters are reset.
Prior to first use
Prior to operating a new appliance for the first time, wipe the top glass-ceramic plate with a wet cloth.
1. Place the appliance on a stable, heat-resistant surface away from other heat sources.
2. Unwind the entire supply cable. Make sure it is not in contact with any heat sources nearby. Insert the plug into the
electric voltage outlet.
3. Check to ensure that the surrounding of the air inlet/outlet grids are open and that there is no danger of the grids
clogging or sucking in an object.
4. Remove small metal items from the surroundings of the appliance; they can become hot or magnetised.
5. Place the cooking utensil containing food in the centre of the heat zone. Use a utensil with a diameter of 120 to
260 mm (210 mm is the best). The safety fuse prevents utensils with a diameter less than 120 mm from heating to
avoid the unwanted heating of other metallic items, such as nearby cutlery, spoons, and other items.
6. To switch on the hob, press the ON/OFF symbol (1). If you do not make a further selection within 1 minute, the hob
automatically switches off.
7. The appliance is equipped with 2 methods of setting up the heat zone power level:
a) Selection of preset function:
- press one of the symbols of the preset function (5), (6) or (7)
b) Selection of desired power:
- press +/- function (8) and then set the power value using the buttons „ +" and „ -" (3)
Unit functions:
a) +/- function selection and subsequent regulation using + and – buttons (3) provides for power control from min
200W up to max 2000 W.
b) STEAM (7) preset function at 1600 W
c) RICE (7) preset function at 1000 W
d) KEEP WARM (7) preset function at 800 W
Note: If the utensil's diameter is too small, or the utensil is made of an unsuitable material, an intermittent sound
signal (beeping) is heard. Use a utensil with a larger bottom diameter or a utensil made of a different material. If you
remove the cooking utensil from the heat zone before it is switched off, the heating is automatically switched off at
once, and beeping signals indicating that the appliance is not properly switched off. If you do not replace the cooking
utensil on the heat zone within 1 minute, the appliance switches off automatically.
8. After you finish cooking by pressing the ON/OFF symbol (1), switch off the hob.
Note: After the hob is off, residual heat in the glass-ceramic plate comes from the cooking utensil. Take extra care as
the hob is hot and you can be burnt (symbol „ H" - hot). This residual heat can be utilised.
9. The cooling fan may continue to operate for several minutes in order to cool the internal electronics. Wait until the
VI1020
47