Heatsail DOME Betriebsanleitung Seite 50

EN
Disconnect remote
Press the "light off" button on the remote control. Switch the left (marked
DIM - 0 - ON) to DIM after six seconds the light will go on and off. Remote
is disconnected.
Reprogramming the remote:
Open the control box and locate the dimmer module.
(1) Switch on the main power
(2) Be aware of any exposed wiring
(3) Find the "Learning Key" on the dimmer module
Min.Set
max.
400W AC 100-240V
L
Register transmitter with the receiver
(1) Press the "Learning Key". The search mode will be active for a short period.
(2) Send a signal to the receiver with the remote by clicking on the "light on"
button on the remote control. If this is first use of the DOME, please be sure
that the protective film on the battery of the remote is removed.
(3) The receiver will store the applicable transmission code in the receivers
memory. If the device successfully paired with the remote, the light of the
DOME will light up briefly (1-2 seconds).
Repeat this procedure to register several remotes, if required. The receiver
can store up to eight transmission codes in its memory. The memory will be
retained if you install the receiver somewhere else or if the power goes off.
50
A1-A2: 8-230V
Learning
Key
N
L N N
L
Light off
H1 H1
OFF ON
H2 H2
OFF ON
Front side
Light on
Heatsail DOME®