Heatsail DOME Betriebsanleitung Seite 38

EN
S T E P 3
Remove remaining items from
the pallet.
S T E P 4
Remove the lid of the metal box
and remove ballast weights, the
black zip tie, and the straight
tube.
S T E P 5
Take the metal box. Position so
that the opening is on the far side.
NOTE: Before continuing, be sure
you place the metal box where
you want the DOME installed for
permanent mounting.
S T E P 6
Look into opening on side of
the metal box and identify the
location of the two screw hole.
Insert M6 button head screw into
the bottom hole of the tube, but
DO NOT tighten it fully at this
time. If you opted for a DOME
with extended height, use both
screw holes, but DO NOT tighten
it fully at this time.
38
Opening
1 2
7 8
1x
Heatsail DOME®
3
4 5 6
9 11 12 13
10