Heatsail DOME Betriebsanleitung Seite 30

EN
1. Electrical safety procedures &
requirements
The use of the DOME requires an electrical installation with reliable safety
grounding. The installation's electrical safety can only be guaranteed if
the device has been correctly connected to a grounding (earthing) system
built in accordance with the safety instructions. A preliminary inspection is
absolutely essential. In the event of any uncertainty, a careful inspection
must be made by a qualified and authorized technician. Heatsail will not be
held responsible for injury and/or damage resulting from an ungrounded
installation.
The installation of the DOME's electrical components requires a main
connection of 230V-50/60Hz (16 Amp fuse EN 30 mA RCD): the connection
must be properly implemented in accordance with the applicable IEC-CEI
standards.
Please note: Statutory and other local regulations may apply. The electrical
power supply will need to be interrupted before the connection or other
work on the electrical components can be carried-out and everyone must
satisfy themselves that the power can't be switched on again accidentally.
The use of adapters, power strips and extension cords may not be used
for the DOME's electrical supply. A switch must be installed between
the DOME and the fuse box at all times. Non-compliance with these
instructions may compromise the safety of the device. Heatsail will not be
held liable for any damage resulting from these issues.
30 Heatsail DOME®