multicomp pro MP700625 Bedienungsanleitung Seite 19

English
Format 2 Output:
The output will be the same value as is on the display. If in parts counting it will
displayed as PCS, if in weighing it is only the weight.
An example output is :
± _ _ _ _ _ _ 1 2 3 . 4 5 _ g _ <cr> <lf>
Parts Counting example:
± _ _ _ _ _ _ _ _ _ 1 2 5 P C S <cr> <lf>
18 Characters, Begins with the sign, a minus sign for negative weight, or a space for positive weight.
For all examples if the weighing unit is one letter (i.e. grams=g) the 2
positions is a space before and after. If it is 2 letters long the 1st and second
position is used with a space after the second letter, (i.e. 0.12345lb__ ) or if it is
3 letters long all 3 positons are used, (i.e 123.45dwt).
Input command format:
The scale can be controlled with the following commands. The commands must be sent in
upper case letters, i.e. "T" not "t".
Tares the scale to display the net weight. This is the same as pressing
T<cr><lf>
[Tare] key.
Sets the zero point for all subsequent weighing. Display shows zero.
Z<cr><If>
T5.345<cr><if> Would be same as entering a preset tare value of 5.345 from keypad
Prints the results to a PC or printer using the optional RS-232 interface.
P<cr><lf>
It also adds the value to the accumulation memory if the accumulation
function is not set to automatic.
15
nd
of the units