Parameter Settings; Unit Setting - Multicomp Pro Mp700625 Bedienungsanleitung

English

5 PARAMETER SETTINGS

Users can press the [Unit] key to view and change parameter settings when the
scale is counting down from POWER UP.
The balance has 5 parameters that can be set by the user.
FUNCTION SECTION
See section 5.1
UNIT F1
See section 5.2
EL F2
See section 5.3
Ser F3
See section 5.4
OFF F4
See section 5.5
SETUP F5
See section 5.6
tECH F6

5.1.1 Unit setting

You can enable and disable the weighing units available to the user when they
press the [Unit] key as described in section 4.2.
• In "Unit F1" mode, press [Tare/Zero] to check the status of each weighing
unit.
•  P ress the [Unit] key to change the state of units.
•  I f unit CUS is selected as "ON", press [Tare/Zero] and the scale will require
the conversion rate between CUS and g. Press [%] to select the digit and
press [Smpl] to change the value. [Print] will to move decimal point. After the
setting is made, press [Tare/Zero] to save changes.
•  P ress [Print] to exit unit mode.
DESCRIPTION
Sets the units to be used
g / ct / GN / N / dr / Lb / oZ / oZt / tl t / tl H / tl S /CUS.
Sets the backlight
AUTO EL : backlight automatically turns on when weight
is applied to the top pan
OFF EL : backlight always off
ON EL: backlight always on
Sets the print parameters
Sets the auto power-off parameter
User set up parameters
Technical parameters setting mode / factory setting
9