Simple Calibration - Multicomp Pro Mp700625 Bedienungsanleitung

English

6 SIMPLE CALIBRATION

Press [Smpl] and [Print] together whilst the display is counting down from
POWER UP, the display will show "unload CAL." 。
Make sure the top pan is empty and when the stable symbol shows press
[Tare/Zero] to enter calibration mode. The [Unit] key allows you to select a
calibration weight value. See the table as below.
Press [Tare/Zero] to select the correct value
The display will show "LOAD WEI". Place the weight onto the pan and press
[Tare/Zero] when the stable symbol shows. If calibration is correct the display
will show "PASS" and then go back to weighing mode.
If the weight placed on is more than 110% of the calibration weight value selected,
the display will show "FAlL H". If the weight placed on is less than 90% of
calibration weight value selected, the display will show "FAlL L".
Users should recalibrate the balance following the correct operation.+
Calibration weights:
Model
Weights（g）
Model
Weights（g）
MP700625 MP700626 MP700627
50 100
70 150
100 200
MP700629 Mp700630 MP700631 MP700632
200 1000
400 1500
500 2000
13
MP700628
200 400
300 500
400 800
2000 2000
3000 5000
4000 6000