Baud Rate Setting - Multicomp Pro Mp700625 Bedienungsanleitung

English
5.1.3 Communication
When the display shows "SEr F3" press [Tare/Zero] to enter the communication
settings.
The following options are available for setting the output and accumulation
functions:
Mode Print Feature
Data is sent whenever the [Print]
Prn 232
key is pressed.
Data is sent continuously.
CON 232
The weighing results will be sent to
AUTO
the communication port
232
automatically whenever a stable
reading is present. The balance has
to return to zero before another
reading is sent via the interface.
Press the [Unit] key to change the setting. Press [Tare] to confirm and
move to the next parameter.
5.1.4 Communication modes
•   P ress [Unit] to go through parameters:
• Auto：sending data automatically when the scale is stable,
• Prn: Press [Print] to send data when the scale is stable.
• CON：the balance will send out data continuously.
•   P ress [Tare/Zero] to save changes and enter baud rate setting.

5.1.5 Baud rate setting

•  P ress [Unit] to go through the settings,
•  F our baud rates are available:
• 1200bps、 2400bps、 4800bps、 9600bps
•  P ress [Tare/Zero] to change the setting and to go back to
communication mode setting,
•  P ress [Print] to exit communication mode.
Accumulation
Manual accumulation when
the [Print] key is pressed.
Accumulation is disabled.
Automatic accumulation
when stable
11