Connection To The Power Supply - ThermoFlow Elex 5.5 Bedienungsanleitung

DE
Incorrect use of this device (e.g. garden hose) or the use of a fitting that
is not suitable for low-pressure installations will cause pressure to build
up in the device. Damage resulting from this is excluded from your war-
ranty and guarantee claims.

Connection to the power supply

The device must be filled with water. Only then can the device to the pow-
er supply connected to .
Please observe the type plate on the device. If the electrical installation
does not meet these requirements, it must be changed. This should be
done by a qualified electrician in accordance with the relevant regulations
(IEEE, etc.).
The device must be properly earthed.
The device must be directly connected to the power supply system (230V).
Avoid hazards from damaged power supply cables.
Make sure that the use of your mini instantaneous water heater does not
overload the fuse protection in your mains.
Internal modifications to the product may cause problems if this work is
not carried out by authorized and qualified technical personnel. The guar-
antee / warranty only applies if the product has not been modified in any
way, i.e. if it is in an unmodified condition.
To avoid creating an unsafe situation by inappropriately resetting the
maximum temperature safety device, do not power this device from an
external switching device (e.g. a timer) or connect it to a circuit that is
regularly switched on and off by the power company.
The device must be filled with water before connecting to the power sup-
ply!
IImportant! Vent the system before commissioning.
Before switching on the power supply, check at the main switch panel
that the hot water circuit is free of air pockets. Otherwise, premature fail-
ure of the element will occur.
（3.25改字体）Manual iwh mini elex v2（2021.03.24改）.indd 17 （3.25改字体）Manual iwh mini elex v2（2021.03.24改）.indd 17
GB
17
2021/3/26 15:34:56 2021/3/26 15:34:56