P Utting Your Display On Standby Mode - De Dietrich DME388 Serie Bedienungsanleitung

99627812_ML_A.qxd 27/03/03
P
utting your display on standby mode
To reduce your oven's power consumption to a minimum when it is not in use, you can
put your readout system in STANDBY MODE.
To carry out this operation, proceed as follows:
GOING INTO STANDBY MODE:
- Your oven must be in normal time readout mode.
- Press both the + and - controls for five
seconds at the same time.
- The display reads "Lcd off"
- Take your fingers off the two controls.
- 30 seconds later your readout will switch off.
Your oven is now in standby mode; whenever
you are in the normal time readout mode, it will
turn off automatically after 30 seconds.
COMING OUT OF STANDBY MODE:
- Your oven must be in the normal time
readout mode.
- Press both the + and - controls for five
seconds at the same time.
- The display reads "Lcd on".
- Take your fingers off the two controls.
- You are now out of the STANDBY MODE; the
readout is now permanently lit.
36
16:07 Page 36
START
STOP
START
STOP
START
STOP
START
STOP