Specifications; Icons; Standard Equipment; Machine Assembly - RIDGID KJ-2200 Bedienungsanleitung

KJ-2200/KJ-3100 Water Jetting Machines

Specifications

Jetter Motor
Model
H.P.
KJ-2200 6.5 / 6,5
KJ-3100
Flow Rate Drain Line Capacity
GPM / liter inch / mm
2.4 / 9 1 1 / - 6 / 32 - 152
4
5.5 / 20 2 - 10 / 50 - 250

Icons

Standard Equipment

All Jetters come with
• Appropriate Jetter Nozzles
• Nozzle Cleaning Tool
• FV-1 Foot Valve
• Engine Operator's Manual
See the RIDGID catalog for specific equipment supplied
with each catalog number.
This machine is made to clean drains. If
NOTICE
properly used it will not damage a drain that is in
good condition and properly designed, constructed
and maintained. If the drain is in poor condition or
not properly designed, constructed or maintained, the
drain cleaning process may not be effective or could
cause damage to the drain. The best way to determine
the condition of a drain before cleaning is through vi-
sual inspection with a camera. Improper use of this jet-
ting machine can damage the jetter and the drain. This
machine may not clear all blockages.

Machine Assembly

To prevent serious injury during use and prevent
machine damage, follow these procedures for prop-
er assembly.

Engine Oil

Jetter is shipped without oil in the engine.
NOTICE
Operating the engine without oil will result in engine
failure. Add oil prior to operation. See supplied engine
operator's manual for specific information on adding
oil and oil selection.
6
1.800.544.2843
Pressure
PSI / bar
2200 / 150
16 3000 / 205
Weight (w/o Hose Reel)
lbs / kg
65 / 30
262 / 119
Pressure Mode
Pulse Mode
WARNING
www.calcert.com
15
10 20
5 25
0 30

Pump/Gearbox Oil

Pump: Replace the plug in the top of the pump and
replace with dipstick/breather cap. Operating the jetter
with the plug in place could damage the pump seals.
Check oil level per Maintenance Instruction section.
Gearbox (KJ-3100 only): Replace the plug in the top
of the pump with dipstick/breather cap. Oper ating the
jetter with the plug in place could damage the gear-
box seals. Check lubricant level per the Maintenance
Instruction section.
Outer Grove
Retaining Clip
Figure 4 – Assembly of the KJ-2200

KJ-2200 Transport Cart

1. Install retaining clip into inner groove on each end
of axle. (See Figure 4.)
2. Slide a wheel over each end of axle.
3. Install retaining clip into outer groove on each end
of axle to retain wheel.
4. Use the supplied carriage bolts and wing nuts to at-
tach the handle to the frame.
5. Lift the motor/pump assembly onto the cart, aligning
the holes in the base plate with the pins in the top of
the cart. Use the latches on the cart to retain the motor/
pump. Make sure the assembly is securely attached.

KJ-3100 Handle Assembly

1. Insert handle through the two holes in the rear cross
bar of the frame. (See Figure 5.)
2. Insert a hairpin through the holes at the bottom of
the handle to prevent the handle from pulling out.
3. Screw the T-knobs into the rear cross bar. Adjust the
handles as desired and tighten the knobs to secure
the handle.
sales@calcert.com