Watching Tv; Selecting The Channels; Selecting The Channels Using The Programme Table - Sharp LL-171ME Bedienungsanleitung

Selecting the channels

This monitor allows you to select up to 100
channels (0-99).
INPUT
MENU
BRIGHT
/
OK
MODE
CH
/BRIGHT
MAIN
POWER
Using the channel buttons (remote control)
To select a 1-digit channel number (e.g., Channel 5):
Select the channel number using one of the
following procedures.
- Press the 5 button and wait for approximately
3 seconds.
- Press the 0 button followed by the 5 button
within 3 seconds.
To select a 2-digit channel number (e.g., Channel 12):
Press the 1 button followed by the 2 button within
3 seconds.
Using the buttons (monitor/remote control)
- Press the button and the channel changes in
the order shown below:
1 → 2 ... → 98 → 99 → 0 → 1 → 2 → ...
- Press the button and the channel changes in
the order shown below:
2 → 1 → 0 → 99 → 98 ... → 2 → 1 → 0 → ...
Notes:
- Pressing one of the above buttons or using the
programme table (see right column)
automatically switches to TV mode if the monitor
is in PC or AV mode.
- Use the INPUT button (monitor) or the TV button
(remote control) to switch the display mode to TV
in the following cases when in PC mode.
- When you are watching TV in the PIP window
(see page E20).
- When you are listening to TV (see page E21).
- Channels set to be skipped cannot be displayed
using the buttons. (See page E31.)
- Channel "0" is reserved for RF output from a
VCR.
All manuals and user guides at all-guides.com

Watching TV

POWER
VIEW MODE PIP
PC TV AV1 AV2
SUBPAGE REVEAL SUBTITLE TEXT
SLEEP MENU
OK
BRIGHT
BRIGHT
MODE
FREEZE
DISPLAY SOUND
/HOLD
CH
E34
Selecting the channels using the
programme table
The programme table shows a list of programmes
in TV memory. They are located in channels 0 to
99. The currently selected programme is displayed
in yellow and child-locked programmes which
have not been cancelled are displayed in red.
1. Select the TV mode using the INPUT button
(monitor) or the TV button (remote control).
2. Press the OK button (remote control).
The programme table will be displayed.
Note:
- While the Teletext screen or the menu screen
is being displayed, you can not display the
programme table by pressing the OK button
(remote control).
PROGRAMME TABLE
00 05
01 E02 06
02 E03 07
03 E04 08
04 09
3. Select the desired programme using the
buttons (remote control).
To display the previous or next list of the
programme table:
- Press the buttons (remote control) when
the cursor is at a programme in the upper-left
or low-right position.
- Press the buttons (remote control) when
the cursor is at a programme in the left or right
column.
4. Display the selected programme using the OK
button (remote control).
< >
TV/AV
10 15
11 16
12 17
13 18
14 19