Herunterladen Inhalt Inhalt Diese Seite drucken

Electrolux ESF 66811 Benutzerinformation Seite 94

Stand-geschirrspüler
Vorschau ausblenden Andere Handbücher für ESF 66811:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

94 electrolux
With the appliance door closed the mal-
function is shown by the fully flashing
blue light of the programme progress
display and an intermittent audible sig-
nal is heard.
Open the door and check which fault code
the digital display shows. Switch off the ap-
Fault codes and malfunction
• continuous flashing of the running programme
light
appears in the digital display
The dishwasher does not fill with water
• continuous flashing of the running programme
light
appears in the digital display
The dishwasher will not drain
• continuous flashing of the running programme
light
appears in the digital display
Anti-flood device is activated
Malfunction
The programme does not start
Once these checks have been carried out
switch on the appliance and close the door.
The programme will continue from the point
at which it was interrupted.
If the malfunction or fault code reappears
contact your local Service Force Centre.
Contact your local Service Force Centre,
quoting the model (Mod.), product number
(PNC) and serial number (S.N.).
pliance and carry out the suggested correc-
tive actions given in the following chart.
For fault codes not described in the chart,
please contact your local Service Force Cen-
tre.
Possible cause and solution
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the water inlet hose
is blocked.
Clean the filter.
• The water inlet hose has not been correctly laid
or it is kinked or squashed.
Check the water inlet hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid
or it is kinked or squashed.
Check the water drain hose connection.
• Close the water tap and contact your local
Service Force Centre.
Possible cause and solution
• The dishwasher door has not been properly
closed.
Close the door.
• The main plug is not plugged in.
Insert the main plug
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel
the delay start.
This information can be found on the rating
plate located on the side of the dishwasher
door.
So that you always have these numbers at
hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis