Initial Operation - Bosch PWS 600 Bedienungsanleitung

Approved Grinding Tools
All grinding tools described in these operating in-
structions can be used (roughing and cutting
discs of synthetic resin-bonded, fibre-reinforced
material).
The permissible speed [rpm] or the circumferen-
tial speed [m/s] of the grinding tools used must
be at least in accordance with the values given in
the table.
Therefore, always observe the permissible
rotational/circumferential speed on the label
of the grinding tool.
max.
[mm]
D
d
100
115
D
b
100
D
115
d
70
b 75
D

Initial Operation

Check for correct mains voltage: The voltage
of the power source must agree with the voltage
specified on the nameplate of the machine.
Equipment marked with 230 V can also be con-
nected to 220 V.
Switching on: Slide the On/Off switch 1
forward.
Switching off: Release the On/Off switch 1.
Locking: Slide the On/Off switch 1
forward and press down
to the front until it latches.
Switching off: Press down the On/Off switch 1
to the rear - the switch springs to
the off position.
Test run!
Check the grinding tool before use. The
grinding tool must be flawlessly mounted
and be able to rotate freely. Perform a test
run of at least 30 seconds without load. Do
not use damaged, out-of-round or vibrating
grinding tools.
17 • 1 609 929 807 • TMS • 02.05.01
[mm]
b d [rpm]
6 16.0 11 000
6 22.2 11 000
– – 11 000
– – 11 000
30 M 14 11 000
30 M 14 11 000
Operating Instructions
Clamp the workpiece if it does not remain
stationary due to its own weight.
Do not load the machine so heavily that it
comes to a standstill.
Roughing and cutting discs become very
hot while working; do not touch until they
have cooled.
Rough Grinding
[m/s]
80
Never use a cutting disc for roughing.
80
Flap disc
80
80
With the flap disc (optional extra), curved sur-
faces and profiles (contour sanding) can be
worked.
45
Flap discs have a considerably higher service life
45
than sanding sheets, lower noise level and lower
sanding temperatures.
Cutting
English - 5
With an approach angle of 30° to
40°, the best roughing results can
be achieved. Move the machine
back and forth with moderate pres-
sure. In this manner, the work piece
will not become too hot, does not
discolour and no ridges are formed.
When cutting, do not press, tilt or
oscillate. Work with moderate ad-
vancing that is adapted to the mate-
rial being worked.
Do not brake coasting cutting disks
with side pressure.
Important is the di-
rection in which cut-
ting is performed.
The machine must
always work opposite
to the direction of ro-
tation.
never move the ma-
chine in the other di-
rection!
the danger exists of it
being
controlled out of the
cut.
Therefore,
Otherwise,
pushed un-