Countdown-Timer; Overload Protection - VOLTCRAFT 684997 Bedienungsanleitung

countdown timer
Use the countdown timer to set a power-on/power-off time when the device is
turned on. Select a power-on/power-off time from 1 minute up to 23 hours and
59 minutes. Touch the switch symbol in the "Action" panel to select power-on
or power-off. Then touch >Start timer< to save your settings. The display will
indicate the selected function with "ON" or "OFF". The display of your mobile
device will show the remaining time until the device powers on or off. When the
pre-set time has elapsed, the power supply switch on or off automatically.

overload protection

Set an overload protection of up to 3699 Watts. You may also set which actions
the product performs in case of overload. Select between "Auto Cut Off" and
"Buzzer Alert". In case of overload detection, the LED on the energy costs
meter flashes red. An additional beep will sound when the "Buzzer Alert" gets
activated. When the overload protection gets triggered, turn off the connected
electric appliance and disconnect the mains plug of the electric appliance from
the socket (4) of the energy costs meter. Then press the on/off button (2).
lower standby consumption
You can set a lower standby consumption between 0.1 and 9.9 Watts. You may
activate or deactivate the standby function. You may also use the "Auto Cut
Off" function to automatically switch off the connected appliance in case the
limit is exceeded.
History data reset
Use this function to delete stored information. Touch >Clear History Data< to
execute this function. Thereafter the values for the electricity tariff, GHG and
the timer settings need to be programmed again.
28