Light (Led); Tips For Saving Energy - Siemens KG N-Serie Gebrauchsanleitung

Before removing the glass shelf, remove
vegetable container and cold storage
compartment.
Fig. *
Simultaneously press holders, lift glass
shelf and pull forwards.
Drawers in the refrigerator
compartment
Fig. (
Pull out the drawer all the way, lift up
and remove.
To insert drawer, place the drawer on
the telescopic rails and push into
the appliance. Attach the drawer by
pressing it down.
Note
Before the vegetable drawer can be
taken out, the glass shelf above must be
taken out.
Taking out the frozen food container
Fig. '
Pull out the frozen food container all
the way, lift at the front and remove.

Light (LED)

Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.

Tips for saving energy

Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool
■
down before placing in the appliance.
Thaw frozen food in the refrigerator
■
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Open the appliance as briefly as
■
possible.
To avoid increased power
■
consumption, occasionally clean the
back of the appliance.
If available:
■
Fit wall spacers to obtain the indicated
energy rating of the appliance (see
Installation instructions). A reduced
wall gap will not restrict the function
of the appliance. The energy rating
may then increase slightly. The gap
of 75 mm must not be exceeded.
The arrangement of the fittings does
■
not affect the energy rating of the
appliance.
en
41