Dimensional Drawing; Instruments Admissions; Commissioning And Maintenance; Releasing The Transducer - Camille Bauer SINEAX F 535 Betriebsanleitung

Output
Output signal
10 11 12 13
– +
0,2
4-20mA
SINEAX F 535
Ord: 000/00F535/010/1
f S = 50Hz; f G = 49.5-50-50.5Hz
230-690V
U U
G S
1 2 3 4 5 6 7
U U
G S
Measuring inputs Power supply
Fig. 5. Declaration to type label.

6. Commissioning and maintenance

Switch on the power supply and the measuring inputs. It is
possible during the operation to disconnect the output line
and to connect a check instrument, e.g. for a functional test.
No maintenance is required.

7. Releasing the transducer

Release the transducer from a top-hat rail as shown in Fig. 6.
Fig. 6
Conformity marks
85-230V DC/AC
40-400Hz 4VA
Works No.
– +
8 9

8. Dimensional drawing

112.5
114.1
Fig. 7. Housing type P13/70 onto a top-hat rail (35 × 15 mm or
35 × 7.5 mm, acc. to EN 50 022).

9. Instruments admissions

Germanischer Lloyd
Type approval certificate: 12 261-98 HH
CSA approved for USA and Canada
file-nr. 204767
FCC Compliance and Canadian DOC Statement
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to both part
15 of the FCC Rules and the radio interference regulations
of the Canadian Department of Communications: These
limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is like to
cause harmful interference in which case the user will be
required to correct the interference at his own expense.
10 11 12 13
1 2 3 4 5 6 7 8 9
70
11