Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Selection of the measured variables for up to 4 internal
counters
• Provision for resetting the maximum value detectors of
output and bus variables (RS 485 only)
• Provision for frequency measurement using either voltage
or current
• Definition of the measured variables on the bus to be
uploaded via the MODBUS interface (RS 485) together
with the device address and the data transfer parameters.
Fig. 12. Bus parameters.
• Measurements displayed: All measured variables selected
on the transducer that has been addressed
• Power system check: Display of all the system values,
ideal as a wiring check (RS 232 only)
• Printing of nameplates.
The "METRAwin10 Software" for the SINEAX DME 440/401
has been especially developed for evaluating measured
variables that are uploaded via the MODBUS interface
(RS 485).
The main features of the software are:
• Simultaneous processing of up to 10 measured variables
that have been uploaded from selected transducers and
time and date stamped
Fig. 13. Digital display.
34
All manuals and user guides at all-guides.com
• Provision for recording minima and maxima
• Continuous recording of up to 4 measured variables
(y/t plot)
• Digital display of up to 4 measured variables with provision
for switching to an analogue display
• Adjustable measurement scanning interval
• Printing of measurements in tables or as curves
• Transfer of measurements to other Windows programs
• Simple setting of parameters
• Provision for saving measurements for subsequent
evaluation
• Provision for saving device configurations for reuse of
settings.
8. Notes of maintenance
No maintenance is required.
9. Releasing the transducer
Release the transducer from a top-hat rail as shown in
Fig. 14.
Fig. 14
10. Dimensional drawings
Fig. 15. SINEAX DME in housing T24 clipped onto a top-hat rail
(35 × 15 mm or 35 × 7.5 mm, acc. to EN 50 022).
15 16 17 18 19 20 21 22 23 24 25 26
1 2 3 4 5 6 7 8 9 11 13 14
87.5
124
Werbung
Inhaltsverzeichnis
