Channel Scan; Dual Scan - Silvercrest PMR-1200 Bedienungsanleitung Und Serviceinformationen

SilverCrest PMR-1200

6.9 Channel Scan

Channel scan will search all available channels for any active stations in a loop.
If you start the channel scan and have selected the CTCSS/CDCSS code "0", all
transmitting stations will be found (with and without CTCSS code).
If you start the channel scan and have selected a CTCSS code between 1 and 38 or a
CDCSS code between 39 and 121, only transmitting stations with CTCSS/CDCSS code will
be found. Stations that do not transmit any CTCSS/CDCSS code will be ignored.

6.10 Dual Scan

Normally your PMR will receive one channel only (with or without CTCSS/CDCSS code).
The dual scan function allows the monitoring of a second channel with CTCSS/CDCSS
code. If a station is detected on the second channel, you can press the PTT button (13)
within the next 5 seconds to answer the received message.
How to enable dual scan:
20
1. Press the
channel scan icon
2. If an active signal is detected on a channel, you can press
the PTT button (13) to cancel the channel scan and to
communicate on this channel: otherwise, the channel scan
will continue automatically after 5 seconds.
3. Press the
continue scanning.
4. Press the
1. Press the
will appear on the display.
2. Press the or
want to monitor.
3. Press the
display the CTCSS/CDCSS code selection.
4. Press the or
5. Press the PTT button (13) to confirm the setting.
button (9) to start the channel scan. The
(29) will appear.
or button to skip the found channel and
button (9) again to stop the channel scan.
button (5) seven times. The dual scan icon
button to set the second channel that you
button to confirm the selected channel and to
button to set the CTCSS/CDCSS code.
Advanced Operation
English