Getting Started; Powering The Pmr On/Off; Adjusting The Volume - Silvercrest PMR-1200 Bedienungsanleitung Und Serviceinformationen

SilverCrest PMR-1200

5. Getting Started

In order to be able to communicate using two PMR units, these must be set to the same
channel and to the same CTCSS/CDCSS code. Furthermore, they must be located within
range (max. 8km in open field).
The RF communications take place on a free (unscrambled) channel, i.e. other people that
have a PMR or a receiver for the set channel will be able to listen to your messages. You
can choose from 8 different channels.
WARNING! Before using the product for the first time, read the safety
instructions starting from page 2 carefully and fully, otherwise material or
personal damage may occur.

5.1 Powering the PMR On/Off

How to power your PMR on
1. Press and hold the
heard and the currently set channel will appear on the display (3).
The unit will be in receive mode as long as it is powered on and not transmitting.
How to power your PMR off
1. Press and hold the
heard and the display (3) will turn blank.

5.2 Adjusting the Volume

14
button (14) for at least 2 seconds. An acoustic signal can be
button (14) for at least 2 seconds. An acoustic signal can be
1. In receive mode, press the
volume. The current volume level (between 1 and 16) will be
displayed.
2. In receive mode, press the
audio volume.
Getting Started
button (11) to raise the audio
button (6) to decrease the
English