Dalla Corte DC PRO XT Benutzerhandbuch Seite 63

Before connecting the machine, make sure that the data on the information
plate corresponds to the characteristics of the electric power supplied. The
information plate is located below the tray on the left side of the machine.
Installation must be carried out in compliance with the regulations in force,
according to the manufacturer's instructions, and by qualified personnel.
The manufacturer shall not be liable for any damage caused by the lack of a
proper earthing system. For safety reasons, the machine must be connected
to a suitable earthing system by a certified electrician who must check that
the electrical capacity of the system is suitable for the maximum power stated
in the machine's information plate.
The installer must perform the water connections observing the best practices
and regulations in relation to hygiene and environmental protection in force
in the place of installation.
The device must be supplied with drinkable water according to the provisions
in force in the place of installation. For the proper operation and efficiency
of the equipment it may be necessary to install an anti-scale water softener.
This assessment must be carried out by the installer of the water softening
device following the instructions in the device's instruction manual.
The machine must be used exclusively for the purpose for which it was expressly
designed. Any other use is to be deemed improper. The manufacturer shall not
be liable for any damage caused by improper, erroneous, or unreasonable use.
| 63