Dalla Corte DC PRO XT Benutzerhandbuch Seite 111

Alarm Cause
Data
This alarm is triggered when there
loss is a data loss in the EEPRO, that is,
when all the settings defined during
installation are lost and the machine
returns to the factory defaults
Clock This alarm is triggered when the
failure clock's internal module does not
work; as a result the timer, if active,
is automatically deactivated
CPU This alarm is triggered when the serial
serial transmission between the electronic
port board of the front panel and the power
failure board are no longer able to communicate
with each other
24V This alarm is triggered when the
alarm
required supply of 24 volt voltage
necessary for the operation of all
internal devices is not present
Effect
Tap DEL on the display to cancel
the alarm and contact an authorized
technical service provider
Tap DEL on the display to cancel
the alarm.
If the alarm repeats, contact an
authorized technical service provider
Equipment completely blocked.
If the problem persists after an attempt
to reset the equipment via the general
switch, contact an authorized technical
service provider
Equipment completely blocked.
If the problem persists after an attempt
to reset the equipment by means of the
general switch, contact an authorized
technical service provider
| 111