Pkm KH-60KHSX Bedienungsanleitung Seite 60

I
NSTRUCTIONS FOR THE QUALIFIED PROFESSIONAL
The power of each LED - illuminant must not exceed 1.5 W.
1. The LED - illuminant should have cooled down before you remove it.
2. Open the extractor hood using the « O
X
3. Remove the used LED - illuminant carefully using a flathead screwdriver.
4. Pull the LED - illuminant out of its holder carefully.
5. Unplug the illuminant wire.
6. Replace the used LED - illuminant by a new one of the same type and power.
7. Connect the plug of the illuminant wire with the new LED - illuminant.
8. Push the new LED - illuminant into its holder carefully until it snaps into place
properly.
--- m = 0.45 m
WARNING! Any damage to the appliance caused by improper
replacement of the illuminant is not subject to the guarantee!
(
ELECTRICAL ENGINEER
B
UTTON FOR THE OPENING OF THE EXTRACTOR HOOD
Required minimum distance to surfaces such as pot lids, oven
cloths etc. to avoid any hot parts and risk of fire.
Only use self-shielded illuminants to avoid hot parts, risk of fire
and exposure to UV-radiation.
~
)
» - button (X).
PEN
~
60