Protecting The Environment - DeWalt D24000 Originalanweisungen

EnGLIsh
Draining the Water Basin (Fig. V)
1. The water basin must be drained after each use.
2. Place the water pump on the tray 69 .
3. Place a suitable container under the drain plug
4. Remove the drain plug.
5. Allow ample time for the liquid to drain.
6. After the liquid has been drained, re-install the drain plug.
7. Dispose of the liquid with due care for the environment.
Adjusting the Table Rolling Resistance (Fig. W)
To take out the clearance between the table and the rails, proceed as follows:
1. Loosen the rail height screws 70 .
2. Adjust the rail height adjusters 71 until the table moves smoothly.
3. Tighten the rail height screws.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of the main housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear approved eye protection and approved dust
mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic
parts of the tool. These chemicals may weaken the materials used in these parts. Use a
cloth dampened only with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
Before use, carefully check the cutting disk guard to determine that it will operate properly.
Ensure that mud, or work-piece particle cannot lead to blockage of one of the functions.
In case of workpiece fragments jammed between cutting disk and guard disconnect the
machine from the power supply and follow the instructions given in section Mounting the
cutting disk. Remove the jammed parts and reassembling the cutting disk.
Keep the ventilation slots clear and regularly clean the housing with a soft cloth.
The following cleaning operations must be performed every day.
1. Insert the water pump into a bucket of clean water and pump the water through the
hose system.
2. Wipe the rails and support arm with a grout sponge or a rag.
3. Spray the water basin and the sliding table with clear water. Wipe any dust residue away
with a grout sponge.
Storage
Store the equipment and accessories out of children's reach in a dark and dry place at above
freezing temperature. The ideal storage temperature is between 5 °C and 30 °C.

Protecting the Environment

Separate collection. Products and batteries marked with this symbol must not be
disposed of with normal household waste.
Products and batteries contain materials that can be recovered or recycled reducing
the demand for raw materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at www.2helpU.com.
34
29 .