SmartGyro e-Xplorer Bedienungsanleitung Seite 39

Charge connection:
Remove the rubber cap, insert the charging cable. If you want, you can remove
the battery and take it where it is most comfortable for you.
Charging your smartGyro
Make sure your smartGyro charger is in optimal condition. Check that
there is no dust or dirt on the connector and if so, clean it and make sure
it is dry.
Always use the original charger provided with the product and connect it
correctly to the device (do not use any other cable than the original one)
and to a power outlet. It is important that you always use the charger that
comes with your smartGyro, otherwise it may cause device failure and
not be covered by the warranty. Once the product is charged, it will take
approximately two to three hours to fully charge.
When the LED light turns green, it means the product is fully charged
English
e-Xplorer - User Manual
smartgyro.es
37