Philips RQ1285 Gebrauchsanleitung Seite 64

english
64
Problem
RQ1285,
RQ1260/21,
RQ1250/21
only: The Jet
Clean System
does not work
when I press
the on/off but-
ton.
RQ1285,
RQ1260/21,
RQ1250/21
only: The shaver
is not fully
charged after
I charge it in
the charger/Jet
Clean System.
The shaver is
fully charged,
but the display
shows less
than 60 shaving
minutes.
Possible cause
You have used another cleaning luid
than the original Philips cleaning
luid.
The Jet Clean System is not con-
nected to the mains.
You have not placed the shaver in
the Jet Clean System properly, so
there is no electrical connection
between the Jet Clean System and
the shaver.
You have not placed the shaver
in the charger/Jet Clean System
properly.
The shaver is equipped with an
intelligent self-learning system that
monitors the shaver's energy con-
sumption and converts the remain-
ing battery capacity into shaving
minutes. The energy consumption
and therefore the remaining number
of shaving minutes depend on your
skin and beard type and your shaving
behaviour (e.g. the use of shaving gel).
Solution
Only use HQ200
Philips Cleaning Fluid.
Put the small plug in the Jet
Clean System and put the
adapter in the wall socket.
Press the shaver tightly into
the holder to lock it into
place.
Make sure you press the
shaver until it locks into
place.
If the number of shaving
minutes of the fully charged
shaver is less than 60
minutes, this is completely
normal and does not mean
that the battery capacity of
the shaver has diminished.