Philips RQ1285 Gebrauchsanleitung Seite 63

Problem Possible cause
Speciic types only: The Jet Clean
System has not cleaned the shaver
properly, because the cleaning luid
in the cleaning chamber is soiled or
the cleaning luid level is too low.
The shav- The rechargeable battery is empty.
er does not
work when I
press the on/off
button.
Speciic types only: The travel lock
is activated.
The shaving unit is soiled or dam-
aged to such an extent that the
motor cannot run. In this case, the
shaving unit symbol, the tap symbol
and the exclamation mark lash.
The temperature of the shaver is
too high. In this case, the shaver
does not work and the exclamation
mark on the display lashes.
The cleaning luid in the cleaning
RQ1285,
RQ1260/21, chamber is soiled.
RQ1250/21
only: The shaver
is not entirely
clean after I
clean it in the Jet
Clean System.
The cleaning luid level is too low.
If the luid volume in the cleaning
chamber drops below the minimum
level during the cleaning program, the
program aborts.The cleaning light
and the 'cleaning chamber empty'
symbol lash at intervals and the
holder returns to its starting position.
english
Solution
Clean the shaver thoroughly
before you continue shav-
ing. If necessary, clean and
reill the cleaning chamber
(see chapter 'Cleaning and
maintenance').
Recharge the battery
(see chapter 'Charging').
Press the on/off button for
3 seconds to deactivate the
travel lock.
Clean the shaving unit or
replace it (see chapters
'Cleaning and maintenance'
and 'Replacement').
Switch off the shaver and let
it cool down. As soon as the
temperature of the shaver has
dropped suficiently, you can
switch on the shaver again.
Empty and rinse the clean-
ing chamber and reill it with
new cleaning luid.
Reill the cleaning chamber
with cleaning luid to a level
between the two lines (see
chapter 'Cleaning and main-
tenance').
63