Symbols And Signs; Installation - BATTIPAV Expert 400 Bedienungsanleitung

Battipav srl

SYMBOLS AND SIGNS:

Danger/prohibition stickers are applied to the machine where necessary. Look at these prior to using the machine.
42
A1 Use of prescribed PPE obligatory (Safety eyewear and earmuffs)
A2 Read operating instructions before each use.
A3
Use of prescribed PPE obligatory ( Protective Gloves )
A4 Warning! Danger of accidental contact
A5 Do not use discs for wood or metal
MANUFACTURER AND MACHINE
The nameplate shown is fitted directly on the machine. It indicates all the references and information necessary for safe operation.
41
A Machine model
B Item
C Serial number
D Power supply voltage
E Power supply frequency
F Current absorption
G Installed power rating
H Tool rotation speed
I Class of protection
L Starter capacitor

INSTALLATION

TRANSPORT
The EXPERT machine can be easily moved by using the transport handles.
Before transporting the machine, ensure that:
• The sliding carriage is fixed by locking the carriage;
• The motor head is completely down by the lever to recovery;
1
• The legs are in transport position
IN ORDER NOT TO COMPROMISE THE MACHINE STABILITY, KEEP STRICTLY TO THE FOLLOWING PROCEDURES.
HOLD THE MACHINE DURING THE WHEEL KIT INSTALLATION OPERATIONS.
1
To carry the machine to use a tie rod with four arms, capable of lifting 200 kg or at least 20% more than the weight of the
machine, engaging the hooks into the carrying handles.
HANDLING
By using the "transport wheels" accessory, the machine can be moved in the yard. When the machine is in working position:
IN ORDER NOT TO COMPROMISE THE MACHINE STABILITY, KEEP STRICTLY TO THE FOLLOWING PROCEDURES.
HOLD THE MACHINE DURING THE WHEEL KIT INSTALLATION OPERATIONS.
a) loosen the left leg locking pin (motor side);
2
b) lift the leg and put it in the wheel support
c) block the leg with its locking pin
2
d) tighten the wheel support setscrew
e) repeat the operation for the right leg.
IN ORDER TO FACILITATE THE ELITE MACHINE MOVEMENT IN THE YARD, WE RECOMMEND LOWERING IT UNTIL
THE LOWERED POSITION.
a) loosen the leg locking pins on the front side, one at a time, holding the machine from the transport handles;
b) lower the machine front side, making the legs slide inside the supports until the leg middle hole matches the hole of the
supports;
3
c) lock the legs by means of the relevant leg locking pins;
d) repeat the operations indicated in points (a), (b), (c) for the rear side (motor side).
4
MOVE THE MACHINE AS INDICATED IN PICTURE 4
POSITIONING
Place the machine on a stabile surface.
B1
Do not wash with water under pressure
C1 Recovery tank water level
D1
Warning! Secure the carriage
E1 Change direction of rotation
F1
Laser Accessory / Instructions
M IP Level
N Year of manufacture
O Max tool diameter
P Internal tool diameter
Q Accessories
R Accessories
S Manufacturer's name
T Manufacturer's name and address
U Certification Marks
GB
43