Troubleshooting; Fault Table; Wear Parts - Weidmuller Cutfix-Serie Originalbetriebsanleitung

8

Troubleshooting

If a fault cannot be resolved by means of the ac-
tions described here, please refer to Weidmüller
Service.

8.1 Fault table

Fault Possible cause
Machine cannot be No power supply
switched on.
Increased scrap Cutting blade damaged or blunt.
Setting shifted
Length deviation Worn toothed belt
Slip
Motor blocked. Cable feed sluggish

8.2 Wear parts

Product
Cutting blade (set)
Double-sided toothed belt
Toothed belt (motor)
40
Recommended action
► Check the power cable and the mains con-
► Check fuses.
► Replace the blade (see section 8.3).
► Check the setting.
► Replace the toothed belt.
► Perform a slip correction
► Check the cable feed.
► Adjust the speed of the cable feed.
Order no.
9054740000
9054750000
9054760000
nections.
(see section 5.13).
2583070000/00/04.2018