Resetting The Daily Piece Quantity; Setting Cable Monitoring Function; Setting The Zero-Overlap Cut; Setting The Program Start - Weidmuller Cutfix-Serie Originalbetriebsanleitung

5.8 Resetting the daily piece quantity

► Open Menu 7.
► Continuously press C for at least 5 seconds.
The daily piece quantity is reset to zero.

5.9 Setting cable monitoring function

If this function is active, the machine detects whether there
is a wire between the feed rollers.
► Open the menu item "Cable monitoring" in Menu 6.
► Use the arrow keys to select the required setting (1 =
active, 0 = not active).
► Press E to save the setting.

5.10 Setting the zero-overlap cut

If this function is active, a zero-overlap cut is carried out at
the start of every program.
► Open the menu item "0-cut" in Menu 6.
► Use the arrow keys to select the required setting
(1 = active, 0 = not active).
► Press E to save the setting.

5.11 Setting the program start

If this function is active, the machine is started via a linked
PC and not via the start button.
► Open the menu item "PC start" in Menu 6.
► Use the arrow keys to select the required setting
(1 = active, 0 = not active).
► Press E to save the setting.

5.12 Setting the start-up speed

The speed with which the machine ramps up after being
switched on can be modified.
► Open the menu item "Ramp motor" in Menu 6.
► Use the arrow keys to select the required setting
(1 = fast, 10 = slow).
► Press E to save the setting.
2583070000/00/04.2018

5.13 Setting the length correction function

You can correct the cable feed via the length correction
function.
► Open the menu item "Correction" in Menu 6.
► Use the arrow keys to select the required value
(-99 mm... +99 mm).
► Press E to save the setting.
Setting up the machine
31