Hauck Varioguard Gebrauchsanweisung Seite 37

GB
shoulders (24, 25).
To adjust the height of the headrest firstly open the harness
buckle by pressing the red button in the centre of the buckle (26)
locate the harness adjustment lever (M) which is located behind
the seat cover in-between the harness straps (23). Pull this lever
towards you and move the headrest up or
down to the appropriate height and release.
Try to move the headrest to check it is locked in position.
HARNESS TENSION AND ADJUSTMENT
Loosen the Harness: Press on the Harness Adjustment Button (L)
positioned near the front of the car seat, and pull on the two
shoulder straps simultaneously (22).
Tighten the Harness: Pull firmly on the Harness Adjustment Strap
(O) at the front of the car seat; it is not necessary to press on the
Adjustment Button (28).
MAINTENANCE ADVICE
WARNING! TOXIC CLEANING FLUIDS CAN CAUSE ILLNESS.
NEVER USE BLEACH, DO NOT IRON, DO NOT MACHINE
WASH, DO NOT TUMBLE DRY AS THIS COULD DAMAGE THE
COVER AND REQUIRE REPLACING.
The car seat cover is removable and washable. In case of light
staining, clean using a damp cloth or soapy water. The cover can
be removed completely and hand washed up to 30°c.
REMOVING THE COVER AND ACCESSORIES
Firstly you will need to remove the cover from around the headrest
section of the car seat. To do this simply pull the cover from
around the top of the headrest, then remove from the base of the
headrest.
Then pull the harness straps through the cover.
Next release the cover from around the edges of the car seat by
releasing the elasticated straps at the front edge of the car seat.
Remove the harness shoulder straps and connectors from the
harness pads.
37