Hauck Varioguard Gebrauchsanweisung Seite 31

le by checking that the indicators on the isofix points (S) are
green (17)!
- Check that the support leg is fully folded out (3), that the lower
part of the leg is locked into position and the indicator on the
foot of the support leg is green (8)!
- Check that the car seat base is installed securely and firmly in
the vehicle!
REMOVING THE BASE - when attached to the ISOFIX points
Squeeze together the two isofix connection adjustment buttons
(R) located on either side of the support leg at the front of the car
seat base and pull the away from the vehicle seat (19).
Unlock the isofix points (Z) by pulling both latches (Q) toward the
front of the vehicle seat (20).
Then pull the car seat base forward on the vehicle seat to release
from the vehicle (21).
REARWARD FACING FOR GROUP 0+
(Birth to 13kg / birth to approx. 18 months)
Firstly you must install the car seat base into your vehicle using
either the seat belt or ISOFIX points. See sections 'Installing the
base - with a seat belt' or 'Installing the base - with ISOFIX'.
You must also ensure that the harness and headrest is set
correctly for your child, to do this see sections 'Headrest and
Safety Harness Adjustment' and 'Harness Tension and
Adjustment'.
The seat includes a seat liner and head hugger (C1) for the small
baby.
The liner has a cushion inserted in a pocket on the back of the
liner which is suitable for children up to approx 9Kg or 12 months.
For children over 9kg or 12 months remove the cushion and use
only the liner while the car seat is rearward facing.
INSTALLING THE CAR SEAT ONTO THE BASE FULLY
RECLINED
Firstly make sure that the seat is in its fully reclined position. With
GB
31