Installing Your Child In The Car Seat - Hauck Varioguard Gebrauchsanweisung

GB
the car seat facing towards the rear of the vehicle, locate the bars
on the underside of the seat onto the attachment points on the
base and press the car seat down until you hear a "click" (19).
Check the seat is secure by lifting the seat upwards.
To remove the car seat from the base, press the car seat release
button (Y) at the front of the base while lifting the car seat up from
the base (10, 11).

INSTALLING YOUR CHILD IN THE CAR SEAT

Firstly open the buckle by pressing the red button in the centre of
The buckle (26). Then sit your child in the car seat, passing their
arms through the shoulder straps.
Bring the harness connectors together and insert into the buckle
until you hear a "click" (27).
Tighten the harness by pulling on the harness adjustment strap
(28), once tight make sure that there is no more than a fingers
width between the harness and your child.
The child's head should sit directly in the middle of the headrest
and the sides of the headrest should sit just above the child's
shoulders, and the shoulder straps should be level with or below
your child's shoulders (25).
If this is not the case please refer to section 'Headrest and Safety
Harness Adjustment'.
CHECKLIST
WARNING! A CORRECTLY ADJUSTED HARNESS IS
ESSENTIAL FOR YOUR CHILD'S PROTECTION. THERE
SHOULD NOT BE MORE THAN A FINGERS WIDTH BETWEEN
THE HARNESS AND YOUR CHILD.
However safe a child seat is, however well built it is, your child's
safety depends on you carrying out the following checks before
every journey.
- Set the harness correctly and to the correct shoulder
height (22 - 28)!
- Ensure the harness straps are not twisted!
- Check the harness is set for the clothing and not loose!
32