Replacing The Fuse; Technical Specifications - Omnitronic DFE-212 Bedienungsanleitung

There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Please note: This fuse is being used for both 115 V and 230 V.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
or
Power consumption:
Inputs:
Nominal Operating Level:
Max. input level:
Input impedance:
Outputs:
Max. output level:
Output impedance:
Frequency range:
Distortion:
S/N-ratio:
Crosstalk:
MIDI-Interface:
Converters:
Sampling rate:
Dimensions (WxDxH):
Weight:
Please note: Every information is subject to change without prior notice. 28.05.2004 ©
220-250 V AC, 50 Hz ~
110-120 V AC, 60 Hz ~
10 W
XLR or balanced ¼" jack
-20 dB to +4 dB
+16 dB at +4 dB nominal level, +2 dB at -20 dB nominal level
40 Ohms balanced, 20 Ohms unbalanced
XLR or balanced ¼" jack
+16 dB at +4 dB nominal level, +2 dB at -20 dB nominal level
66 Ohms balanced, 33 Ohms unbalanced
20 Hz - 20 kHz
0.06 %
98 dB, 20 Hz - 20 kHz
-95 dB, 20 Hz - 20 kHz
5-pin DIN-socket IN/OUT/THRU
24-bit Sigma-Delta, 64/128-times oversampling
48 kHz
482 x 152 x 45 mm
3 kg
22/22 10356510_V_1_0.DOC