Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The first Auto-filter „locks" the feedback frequency while the remaining auto-filters keep searching for other
feedbacks and suppress them. After all auto-filters are occupied, the filter with the oldest setting will be
released in order to keep searching for new feedbacks.
The auto-mode is recommended for all portable microphones. In this way, upcoming feedbacks can be
surpressed effectively.
Single (SING)
Feedbacks in certain frequencies are automatically detected and supressed with the smallest possible
bandwidth and cut. Afterwards, the filter is locked. The adjusted frequency will permanently be monitored
and does not change any more. The DFE-212 automatically adjusts the bandwidth and cut.
Adjusting the sensitivity
The sensitivity of the DFE-212 can be adjusted for both auto-modes. In its original setting the sensitivity is
set to–6 dB. This sensitivity is perfect for most applications. If you set the sensitivity to –3 dB, the sensitivity
is lowered, i.e. the device reacts more slowly to upcoming feedbacks. If you set the sensitivity to –9 dB, the
highest sensitivity is reached (e.g. for speech transmission).
Press and hold the Filter Mode-button and press the jog-wheel. The display shows SENS: and the current
sensitivity. Adjust the desired sensitivity via the jog-wheel and quit the mode by pressing the Filter Mode-
button.
Bypass-function
By pressing the Bypass-function, all adjustments will be deactivated. The display shows EQ-OF. This
function allows to compare the original signal with the modified parametric equalizer signal.
Please note: when you activate the Bypass-function, all surpressed feedback frequencies are deactivated.
Danger of immediate feedbacks!
Restoring the original settings
Press and hold the Filter Select-button and the Store-button while turning the device off and on again. The
original settings are loaded.
Please note that all adjustements will be deleted.
Please refer to the illustration in the annex for viewing the presets.
MIDI-settings
Press and hold the Bypass-button and press the Store-button in order to enter the Midi-menu.
Press the Bypass-button in order to navigate the Midi-menu.
Channel select (CH-XX)
Select the desired Midi-channel via the jog-wheel. When you want to switch off the Midi-function, select CH-
OFF.
Omni-mode
In the Omni-mode, the DFE-212 sends and receives all data on all Midi-channels.
Adjusting the receive/send options
Control 0
The DFE-212 ignores all controller data.
Control 1
Controller data is received but not sent.
20/22
10356510_V_1_0.DOC
Werbung
Inhaltsverzeichnis
