Safety Information - Miomare IAN 354966 2004 Gebrauchsanweisung

Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following instructions for
use carefully.
Use the product only as described and only
for the given areas of application. Store these
instructions for use carefully. When passing the
product on to third parties, please also hand
over all accompanying documents.
Package contents (Fig. A)
1 x toothpaste dispenser (1)
2 x toothbrush cup, large (2)
2 x toothbrush cup, small (3)
1 x holder (4)
1 x instructions for use
Technical data
Dimensions: approx. 25.7 x 15 x 9.1cm
(W x H x D)
Maximum load: 2kg
Date of manufacture (month/year):
10/2020
Intended use
The product was developed as a toothpaste
dispenser for private use.
The product is not intended for commercial use.

Safety information

• Never leave children unattended with the
packaging materials. There is a risk of
suffocation.
• Only adhere the product to tiled surfaces.
Other surfaces could become damaged.
• Do not exceed the maximum load capacity
of 2kg.
• Ensure that children do not hang from or pull
on the product. The product can fall down.
• Check the product for damage or wear before
each use. The product may only be used if it is
in perfect condition!
Mounting
1. Before mounting the product, thoroughly
clean the wall where the holder (4) is to be
glued. This spot must be free of dust and other
contaminants (Fig. B).
Note: align the holder as straight as possible.
Use a level to help.
2. Remove the protective film from the adhesive
strip on the holder (Fig. B).
3. Press the side of the holder with the adhesive
strip horizontally against the cleaned area for
approx. 12 seconds (Fig. B). Make sure that
no visible bubbles form, otherwise the holder
may not adhere properly.
Note: fastening the holder with the adhesive
strip means it cannot be moved later. Removing
the holder may damage the backing layer or
adhesive. For this reason, only adhere the holder
to tiled surfaces.
4. Push the toothpaste dispenser (1) over the
holder from above (Fig. C).
Use
1. Unscrew the screw cap of the toothpaste and
remove any other seals.
2. Applying light pressure, twist the tube into the
silicone insert (Fig. D).
3. Open and attach a second tube.
4. Place the large cups (2) into the left and right
of the toothpaste dispenser (1) from above
with the opening facing downward (Fig. E).
5. Place the small cups (3) into the left and right
of the toothpaste dispenser from below with
the opening facing downward (Fig. E).
Note: the small cups are held onto the
toothpaste dispenser by magnets.
6. Insert the brush head into the opening below
the tube and lightly press against the pump
system (1a) in order to dispense a sufficient
amount of toothpaste (Fig. F).
Note: the amount may vary depending on the
size of your brush head. The amount depends
on how far you insert the brush head. The further
you insert it, the greater the amount.
7. Use the oval compartment on top for dental
utensils, such as dental floss.
GB/IE 7