Safety Instructions - Uponor Smatrix Base PRO Kurzanleitung

1 Safety instructions

EN
Note
This quick start guide serves as a reminder for
experienced installers.
We strongly recommend reading the full manual before
installing the control system.
See QR code for download link.
Note
The general handling of thermostats in this manual is
also valid for Uponor Smatrix Base Pro X-148 Modbus
RTU.
1.1 Controller
Warning!
The Uponor system uses 50 Hz, 230 V AC power. In
case of emergency, immediately disconnect the power.
Warning!
Risk of electrical shock! Electrical installation and service
behind secured 230 V AC covers must be carried out
under the supervision of a qualified electrician.
Warning!
The transformer module is heavy and might detach if the
controller is held upside down without the cover on.
Caution!
To avoid interference, keep installation/data cables away
from power cables of more than 50 V.
Caution!
Ensure that each actuator is connected to the correct
channel so that the thermostats are controlling the
correct loops.
Note
Wires between transformer and room controller card
needs to be disconnected prior to detaching the
transformer.
Note
Connect only one actuator for each channel. Channels
01 and 02 have double outputs (a and b) for two
actuators.
4 | Uponor Smatrix Base PRO | Quick guide
Uponor Smatrix Base PRO
1.2 Thermostat/system device
Caution!
If more than one room controller is available in the
system, register the thermostat as a system device to the
master room controller.
Caution!
The switches in the public thermostat must be set before
the thermostat is registered.
Caution!
The switches in the public thermostat must be set to one
of the available functions, otherwise it cannot be
registered.
Note
Registration of at least one thermostat must be done
before registering a system device.
Note
Up to 16 controllers can be registered to an interface.
Quick guide