Troubleshooting - CombiSteel 7450.0840 Gebrauchsanweisung

Troubleshooting

If your appliance develops a fault, please check the following table before making a call to your dealer.
Fault
The unit is not switched on
Plug and lead are damaged
The appliance is
Fuse in the plug has blown
not working
Power supply
Internal wiring fault
Too much ice on the evaporator
Condenser blocked with dust
Doors are not shut properly
The appliance
Appliance is located near a heat source
turns on, but the
or air flow to the condenser is being
temperature is
interrupted
too high/low
Ambient temperature is too high
Insufficient airflow to the fans
Appliance is overloaded
The appliance is not properly levelled
The discharge outlet is blocked
The appliance is
Movement of water to the drain is
leaking water
obstructed
The water container is damaged
The drip tray is overflowing
The safety band has not been removed
The appliance is
Loose nut/screw
unusually loud
The appliance has not been installed in a
level or stable position
Probable Cause Action
Check if the unit is plugged in correctly and
switched on
Call your agent or qualified technician
Replace the fuse
Check power supply
Call your agent or qualified technician
Defrost the appliance
Clean the condenser
Check if doors are shut and seals are not
damaged
Move the appliance to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any blockages to the fan
Reduce the amount of food stored in the
appliance
Check installation position and change if
necessary
Clear the discharge outlet
Clear the floor of the appliance (if applicable)
Call your agent or qualified technician
Empty the drip tray (if applicable)
Remove the safety band
Check and tighten all nuts and screws
Check installation position and change if
necessary
6