Receiver Installation - Protector AS-5020.3 Betriebsanleitung

WIRELESS EXHAUST AIR CONTROL AS-5020.
Assembly and operating instructions for an exhaust
air controller Model AS-5020.
Thank you for purchasing the PROTECTOR
AS-5020. . Exhaust Air Controller.
3
GENERAL
This device can be used as an exhaust air control
device, as an aid to monitor fresh air supply when
commissioning an exhaust air device (fume extractor
hood, fan etc...).This cannot replace self-monitoring
to ensure fresh air supply, but it can be supportive.
This device only activates the exhaust air system in the
event of pressure equalisation when a window or door
is opened. The additional fresh air streaming in can thus
be drawn in from the outside.
You can also use this device to selectively switch
devices or lamps ON or OFF, for instance when a door
or a window is closed or opened. This, for example,
enables significant reduction of energy costs for heating
or air-conditioning devices.
ATTENTION
When using this device for exhaust air control,
the shutter must be open to ensure adequate
inflow of fresh air!
USE OF ADDITIONAL TRANSMITTERS
(MAX. 8 DEVICES)
The device functionality can be extended by adding
more transmitters (window contacts) with the result
that the extractor hood is not limited to a single
window only. Each individual transmitter can activate
the exhaust air device.
12
AS 5020.3 Manual @150x180_06/2020.indd 12
(radio version)
3
3
FUNCTION SELECTOR SWITCH
You can select two functions (effective directions) with
the sliding switch (1) of the receiver. In the (OPEN)
switch position, the connected device is activated when
a window is opened (e.g. for exhaust air control use).
In the (CLOSE) switch position, the connected device
(e.g. air-conditioner, heater) switches off when a
window is opened.
NOTE
As long as the receiver is plugged into the wall socket,
a switching is not possible. To reverse the effective
direction, the receiver must be removed from the
socket, the switch be slid and the receiver be replaced
into the socket.

RECEIVER INSTALLATION

Plug the AS-5020. receiver into a socket. Plug the
3
device to be switched into the receiver socket and
screw on the additional fuse (S). The power LED on the
receiver is now on and the receiver is ready for use.
NOTE
The receiver should not be mounted behind a metal
covering because this can limit the range.
ATTENTION
Always check that the power rating of the connected
device is less than or equal to the switching capacity.
02.07.20 15:28