Bosch MIC‑ALM‑WAS‑24 Installationsanleitung Seite 32

32 en | MIC-ALM-WAS-24 Layout
10 Terminal block (2-pin, labeled P100) for connections to
11 Push button (red; labeled PUMP ON) to activate/test the
12 Cable gland, size M16, intended for connections to
13 LED (labeled Washer LED) to indicate activity of washer
14 Cable gland, size M16, intended for alarm input/output
15 LED to indicate power (Red indicates power on)
16 LED (labeled ACTIVITY) to indicate communications
2019-12 | 3.0 | F.01U.382.777
1 Hole for lid screw [four (4) total]
2 Hole for mounting screw [four (4) total]
3 Cable gland, size M16, intended for 24 VAC power cable
4 Terminal block (3-pin, labeled P300 / Voltage In) for 24
VAC power cable
5 [Not used]
6 Terminal block (12-pin, labeled P101) for alarm
connections
7 Alarm LEDs (labeled AO1, AO2, AO3, AI1, AI2, AI3, AI4)
8 Terminal block (3-pin, labeled P200) for RS-485
connections
9 Cable gland, size M16, intended for RS-485 connections
from camera
washer
washer
washer
connections [Supplied but not factory-installed]
between the MIC-ALM-WAS-24 and the camera
MIC Alarm-Washer Box
Bosch Security Systems