XBOX 360 Handbuch Und Garantie Seite 18

reGULAtionS
Disposal of electrical &
electronic equipment
This symbol on the product or its
packaging means that this product
must not be disposed of with your
household waste. Instead, it is your
responsibility to hand this over to an
applicable collection point for the recycling
of electrical and electronic equipment. This
separate collection and recycling will help to
conserve natural resources and prevent
potential negative consequences for human
health and the environment due to the
possible presence of hazardous substances in
electrical and electronic equipment, which
could be caused by inappropriate disposal.
For more information about where to drop
off your electrical and electronic waste,
please contact your local city/municipality
office, your household waste disposal service,
or the shop where you purchased this
product. Contact weee@microsoft.com for
additional information about WEEE.
This product is for use with NRTL-listed (UL,
CSA, ETL, etc.) and/or IEC/EN 60950
compliant (CE marked) Information
Technology equipment.
Statement of compliance with
eU Directives
Hereby, Microsoft Corporation declares
that this product is in compliance with the
essential requirements and other relevant
provisions of Directives, 2006/95/EC and
2004/108/EC.
The technical documentation as required
by the Conformity Assessment procedure
is kept at the following address:
company
Microsoft Ireland
Operations Ltd.
Address The Atrium Building 3
Carmanhall Road,
Sandyford Industrial
Estate,
Dublin 18
country
Ireland
16
Laser Specifications
caution
Use of controls or adjustments, or
performance of procedures other than
those specified herein may result in
hazardous radiation exposure.
This device complies with International
Standard IEC 60825-1:2007:03 for a Class 1
laser product. This device also complies with
21 CFR 1040.10 and 1040.11 except for
deviations pursuant to Laser Notice No. 50,
dated June 24, 2007.
The following Class 1 laser label is located on
the foot of the sensor.
caution
Any changes or modifications made on
the system not expressly approved by
the manufacturer could void the user's
authority to operate the equipment.