What To Do If - Electrolux EUC19002W Benutzerinformation

46 electrolux
3. Leave the door open and insert the
plastic scraper in the appropriate seat-
ing at the bottom centre, placing a basin
underneath to collect the defrost water.
In order to speed up the defrosting
process, place a pot of warm water in
the freezer compartment. In addition,
remove pieces of ice that break away
before defrosting is complete.
4. When defrosting is completed, dry the
interior thoroughly and keep the scraper
for future use.
5. Switch on the appliance.
6. Turn the Temperature Regulator to the
<< -18 °C >> position and leave to run
for at least 4 hours in quick freeze
mode.

WHAT TO DO IF...

Warning! Before troubleshooting,
disconnect the mains plug from the
mains socket.
Only a qualified electrician or compe-
tent person must do the troubleshoot-
ing that is not in this manual.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Problem
The appliance is noisy
The compressor oper-
ates continually
Possible cause
The appliance is not supported
properly
The thermostatic control is set
incorrectly
7. After 4 hours reload the previously re-
moved food into the compartments.
Warning! Never use sharp metal tools
to scrape off frost from the evaporator
as you could damage it.
Do not use a mechanical device or any
artificial means to speed up the thaw-
ing process other than those recom-
mended by the manufacturer.
A temperature rise of the frozen food
packs, during defrosting, may shorten
their safe storage life.
Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
1. disconnect the appliance from electricity
supply
2. remove all food
3. defrost and clean the appliance and all
accessories
4. leave the door/doors open to prevent
unpleasant smells.
Important! If the cabinet will be kept on,
ask somebody to check it once in a while to
prevent the food inside from spoiling in
case of a power failure.
Important! The appliance operates
discontinuously, so the stopping of
compressor does not mean being no
current. That is why you must not touch the
electrical parts of the appliance before
breaking the circuit.
Check if the appliance stands sta-
ble (all the four feet should be on
the floor)
Set a warmer temperature
Solution