Fader Start - Denon DN-X300 Bedienungsanleitung

5

FADER START

If the separately sold DN-S5000, DN-S3000, DN-S1000 and etc. players are connected to LINE1, 2, 3 or 4, they
can be started using the source input fader (Ch. Fader) or Crossfader, as long as the 3.5 mm stereo mini cords
have been connected.
LINE
L R L
OUT
LINE4
FADER FADER FADER
PGM1
CD player (DN-S3000)
(1)-2, 5
(2)-1
(1)-1
(1)-4
FADER FADER LINE
R L R
PGM2 PGM1 OUT
LINE2
FADER
PGM2
DN-X300
CD player (DN-S3000)
(1)-2, 5
(2)-2, 5
(2)-1
(1)-1
(1)-4
(2)-4
Channel Fader Start
Turn the CH 1/2 FADER START switches #8 .
1
Move the Channel fader @1 of
CH-1 or CH-2 control all the
way to the bottom.
2
L R
3
Set the standby mode on CD player.
Use the CH 1/2 FADER
CONTOUR controls $1 to
control the Channel fader
4
startup curve.
When you want to start the
player, move up the Channel
fader @1 and the CD player
will begin playing.
5
NOTE:
• When the CH 1/2 FADER REVERSE switch is set
to ON, the Channel fader's operating direction is
reversed.
ENGLISH
Crossfader Start
Turn the CROSSFADER START A, B switches
#9 .
1
Slide the Crossfader @3 all the way in direction
opposite the source you want to start. (In the
following example, startup is done with the CD
player connected to PGM1.)
2
3
Set the standby mode on CD player.
Use the CROSSFADER
CONTOUR control $3 to
control the Crossfader
4
startup curve.
When the Crossfader @3 is slid in the opposite
direction, CD player play will begin.
5
NOTES:
• When the CROSSFADER REVERSE switch is set
to ON, the Crossfader's operating direction is
reversed.
• Channel Fader Start and Crossfader Start for the
same source will not operate simultaneously.
You must select from either one. If both CH
FADER START and CROSSFADER START A, B
switches are ON, priority will be the cross fader.
9